Cart ( 0 ) Register Login

Webstore





RS ISO 14679:1997
Adhesives — Measurement of adhesion characteristics by a three-point bending method
Abstract

This International Standard specifies a test method to determine the ability of a cured adhesive (if
necessary with a primer) to adhere to a substrate with a certain surface finish, or which has been
subjected to a specific surface preparation, using the “three-point bending method”.
This standard is only applicable to quality assurance and only to substrates which are rigid or
resistant enough to bending, such as steel or aluminium alloys. For other substrates, the thickness
is adjusted to the modulus of elasticity or a suitable stiffener is used.
The adhesive is allowed to cure without the application of pressure in order to obtain the
thickness needed to provide sufficient rigidity, otherwise a bonded reinforcing piece of the same
material and the same thickness as the substrate is substituted for the block of adhesive.
This test method is not suitable for film adhesives.

General Information

CodeClassificationThemePagesPublisherAvailability
RS ISO 14679:1997ADOPTED ISO STANDARDSPaint and colour industries17First Edition
Jun 2023		Available
Price: RWF 16,500


View: All

View by: Classification

View by: Group
Agriculture ( 256 )
Metallurgy ( 131 )
Services ( 8 )
Testing ( 5 )
Rwanda Standards Board

© Rwanda Standards Board 2020  - All rights reserved

KK 15 Rd, 49; PO Box: 7099 Kigali-Kicukiro, Tel: +250 0788303492, Hotline: 3250, Email:info@rsb.gov.rw